pycycling.ftms_parsers.control_point module

class pycycling.ftms_parsers.control_point.ControlPointResponse(request_code_enum, result_code_enum)

Bases: tuple

request_code_enum

Alias for field number 0

result_code_enum

Alias for field number 1

class pycycling.ftms_parsers.control_point.FTMSControlPointOpCode(value, names=<not given>, *values, module=None, qualname=None, type=None, start=1, boundary=None)

Bases: Enum

REQUEST_CONTROL = 0

RESET = 1

RESPONSE_CODE = 128

SET_INDOOR_BIKE_SIMULATION_PARAMETERS = 17

SET_SPIN_DOWN_CONTROL = 19

SET_TARGETED_CADENCE = 20

SET_TARGETED_DISTANCE = 12

SET_TARGETED_EXPENDED_ENERGY = 9

SET_TARGETED_NUMBER_OF_STEPS = 10

SET_TARGETED_NUMBER_OF_STRIDES = 11

SET_TARGETED_TIME_IN_FIVE_HEART_RATE_ZONES = 16

SET_TARGETED_TIME_IN_THREE_HEART_RATE_ZONES = 15

SET_TARGETED_TIME_IN_TWO_HEART_RATE_ZONES = 14

SET_TARGETED_TRAINING_TIME = 13

SET_TARGET_HEART_RATE = 6

SET_TARGET_INCLINE = 3

SET_TARGET_POWER = 5

SET_TARGET_RESISTANCE_LEVEL = 4

SET_TARGET_SPEED = 2

SET_WHEEL_CIRCUMFERENCE = 18

START_OR_RESUME = 7

STOP_OR_PAUSE = 8

class pycycling.ftms_parsers.control_point.FTMSControlPointResponseResultCode(value, names=<not given>, *values, module=None, qualname=None, type=None, start=1, boundary=None)

Bases: Enum

CONTROL_NOT_PERMITTED = 5

INCORRECT_PARAMETER = 3

NOT_SUPPORTED = 2

OPERATION_FAILED = 4

SUCCESS = 1

pycycling.ftms_parsers.control_point.form_ftms_control_command(opcode: FTMSControlPointOpCode, parameter: int = 0)

Form a FTMS control command message :param opcode: FTMSControlPointOpCode :param parameter: scalar or list of scalar :return: bytearray

pycycling.ftms_parsers.control_point.parse_control_point_response(message: bytearray) → ControlPointResponse